Pump actuators

Pump actuators, a great selection of pump actuators available at Aquamerik.

Electrical automated lever (WHLP-II)
The Hydrolift-2 is a portable, electrically operated device that is used to automate the operation of the Inertial Pump. The Hydrolift is powered by a 3/4 horsepower electric motor (available in either 110 volts or 220 volts) and generates a 4-inch stroke at up to 200 cycles per minute. The Hydrolift-2 weighs only 35 pounds and requires an electrical power supply of at least 1000 watts. This actuator is optimized to operate with the Standard Flow System up to its maximum effective depth and will operate with the High Flow System up to a depth of 150 feet. This actuator is the ideal choice for the frequent user of inertial pumping systems. IMAGE

Gasoline automated lever (WPP-II)
The PowerPump-2 is the most powerful pump actuator you can find on the market. A Honda GX100, 2.5 horsepower, 4 stroke, gasoline motor powers this device. This actuator generates a 6-inch stroke and can operate both the Standard Flow System and High Flow System to their maximum effective depths. The PowerPump-2 weighs 70 pounds and usually requires two people to carry it. It is an excellent choice for those with extreme pumping requirements. IMAGE

Gasoline powered automatic lever (WPP-1)
The PowerPack (WPP-1) is powerful enough to lift water from over 60m (200 ft) depth using the Standard Flow System, and is so compact that it fits onto a back-pack frame. The WPP 1 incorporates clamps for High Flow and Standard tubing sizes (adapters are available for smaller tubes). A Honda GX-25 series, 1.0 horsepower, 4 stroke, gasoline motor powers this device, which can run for approximately 1 hour without refuelling. It is an excellent choice for those with moderate pumping requirements. IMAGE

Manual lever pump (WLP-100)
This Lever Pump is a manual lever designed to provide operators with a convenient, portable mechanism which would provide some mechanical advantage when manually operating the Inertial Pump as well as facilitating the collection of samples with this system. This actuator will fasten onto most above ground well completions quickly and easily. The tubing clamp is designed to accept Standard Flow, High Flow and Low Flow tubing and the handle is adjustable in order to accommodate various casing diameters and desired stroke lengths. IMAGE